Rotel RDD-06 Manuel du propriétaire télécharger pdf (Page 13)

Input Signal Connections

See Figure 3

The RDA-06 has conventional RCA type input connectors, the type found on nearly all audio equipment. Select high quality audio interconnect cables

for connecting to the RDA-06. Ask your authorized Rotel dealer for advice about cables.

NOTE: To prevent loud potentially damaging noises, make sure the RDA-06 is turned off when you make any changes to the input signal configuration.

Speaker Outputs

See Figure 3

Speaker Selection

The nominal impedance of the loudspeakers connected to each channel of the RDA-06 should be no lower than 4 ohms.

Speaker Wire Selection

Use insulated two-conductor stranded wire to connect the RDA-06 to the speakers. The size and quality of the wire can have an audible effect on the

performance of the system. Standard speaker wire will work, but can result in lower output or diminished bass response, particularly over longer distances.

In general, heavier wire will improve the sound. For best performance, you may want to consider special high-quality speaker cables. Your authorized

Rotel dealer can help in the selection of cables for your system.

Polarity and Phasing

The polarity ă the positive/negative orientation of the connections ă for every speaker and amplifier connection must be consistent so all the speakers

will be in phase. If the polarity of one connection is reversed, bass output will be very weak and stereo imaging degraded. All wire is marked so you